2.3
Installing the monitor hood
Check the monitor hood items as the following:
Right hood
The installation method is as follows:
1. Install the left hood and right hood (Figure 1 in next page):
•
Push towards the monitor A and press down B, make sure that the top edge of
left and right hood are aligned with the monitor.
•
Lock the attached screws.
2. Install the upper left hood and upper right hood (Figure 2 in next page):
•
Place the upper left hood and upper right hood above the monitor, and ensure
that the front edge is aligned with the left or right hood.
•
Then press the upper left hood and upeer right hood down slightly as shown in
the figure until hear two clicks.
•
Lock the screws.
3. Install the upper middle hood (Figure 3 in next page):
•
Snap the U-shaped groove of the upper middle hood onto the upper left hood
and upper right hood, then push down the back half of the upper middle hood.
•
Move the upper middle hood horizontally ensure that in the center position and
screw holes alignment.
4. Lock the screws (Figure 4 in next page).
ASUS PA32UCXR Series LCD Monitor
Left hood
Upper middle hood
Upper right hood
Screws
Upper left hood
2-5