Cleaning - Electrolux UltimateTaste 300 Manual

IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2) HOT PLATE
It is very important to clean the surface soon
after every use.
Periodically wash the hot plate, the pan support,
the enamelled burner caps "A", "B" and "C" and
the burner heads "T" (see fig. 6 - 7) with lukewarm
soapy water. They should also be cleaned plugs
"AC" and safety cut-off devices "TC" (see fig. 6).
Clean them gently with a small nylon brush as
shown (see fig. 8) and allow to dry fully.
Do not wash moving parts in the dishwasher.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
After cleaning to dry the surface of the hob with a
dry cloth.
Do not use metallic sponges, powder
abrasives or corrosive sprays.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner heads slots (see fig. 6 - 7)
have not become clogged by foreign bodies.
- Check that enamelled burner cap "A - B - C"
(fig. 6 - 7) have correctly positioned on the
burner head. It must be steady.
FIG. 6

CLEANING

- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
cooktop.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- To prevent difficulties with lighting, regularly
clean the ignition elements (ceramic and
electrode) and safety cut-off devices (fig. 6).
- Don't use steam jets for the equipment
cleaning.
IMPORTANT:
when removing the burners to clean them,
ensure that all parts are correctly positioned
before relighting them.
Note: continuous use could cause the
burners to change colour due to the high
temperature.
FIG. 7
7
FIG. 8