Table of Contents
Advertisement
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Remove the cover at the top of the oven door. Press in the
2.
tabs on the left and right using your fingers (fig. A).
3.
Lift the top panel up and out (fig. B).
$
Lift the middle panel up and pull it out (fig. C).
4.
&
Lift the lower panel up and out.
5.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
‹‹
‹‹
:
appears in the display.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. A small
square lights up in the temperature dis-
play.
18
%
Possible cause
Defective fuse
Power cut
Type of heating not recognised
The oven is in demo mode.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Insert the middle panel at an angle towards the back (fig. B).
2.
$
Insert the top panel at an angle towards the back into the
3.
brackets. The smooth surface must face outwards. (fig. C).
&
Put the cover back in place and press on it.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly installed.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the clock.
Make the settings again.
Switch off the circuit breaker in the fuse box, then
switch it back on after at least 20 seconds. Within
the next 2 minutes, press and hold the
for 4 seconds until the square disappears from the
display.
%
D
button
Advertisement
Table of Contents
