Table of Contents
Advertisement
MAINTENANCE
To reduce the risk of injury,
WARNING
always unplug the charger and
remove the battery pack from the charger or
tool before performing any maintenance. Never
disassemble the battery pack, charger, or tool,
except as provided in these instructions.
Contact a MILWAUKEE
repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
repair. If the tool does not start or operate at full
power with a fully charged battery pack, clean the
contacts on the battery pack. If the tool still does not
work properly, return the tool, charger and battery
pack, to a MILWAUKEE
ONE-KEY™
Chemical Burn Hazard.
WARNING
This device contains a
lithium button/coin cell battery. A new
or used battery can cause severe in-
ternal burns and lead to death in as
little as 2 hours if swallowed or enters the body.
Always secure the battery cover. If it does not
close securely, stop using the device, remove the
batteries, and keep it away from children. If you
think batteries may have been swallowed or en-
tered the body, seek immediate medical attention.
Internal Coin Cell Battery
An internal coin cell battery is used to facilitate full
ONE-KEY™ functionality.
To replace the coin cell battery:
Remove tool's battery to avoid
1.
WARNING
starting the tool. The coin cell
battery door is located under the battery pack.
2. Loosen the screw(s) and open the coin cell
battery door.
3. Remove the old coin cell battery, keep it away
from children, and dispose of it properly.
4. Insert the new coin cell battery (3V CR2032),
with the positive side facing up.
5. Close the battery door and tighten the screw(s)
securely.
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Some of these include
petrol, turpentine, lacquer thinner, paint thinner,
chlorinated
cleaning
household detergents containing ammonia. Never
use flammable or combustible solvents around
tools.
service facility for ALL
®
service facility for
®
service facility for repairs.
®
Cleaning
solvents,
ammonia
For repairs, return the tool, battery pack and charger
to the nearest authorised service centre.
WARNING
hazardous.
For a complete listing of accessories, go online to
milwaukeetool.com.au / milwaukeetool.co.nz or
contact an authorised distributor.
and
6
Repairs
ACCESSORIES
Use
only
accessories.
Others
recommended
may
be
Advertisement
Table of Contents
