Advertisement
Cleaning the Dicing Grid
NOTES
• Ensure dicing blade has been removed first.
• The dicing grid must remain correctly assembled
to the bowl prior to using the dicing cleaner.
• The dicing gearbox can remain inside the bowl
and grid.
1. Take cleaner out of caddy and flip up handle
2. Align and then insert cleaner tabs into grid slots
making sure the cleaner is upright
3. With one hand, grasp the cleaner handle. With
your other hand, put pressure/hold down the
blank side of the grid.
4. Push the cleaner handle down towards the
bowl rim, maintaining pressure on the grid with
your other hand - Food should begin to be
pressed through the grid and int the bowl.
5. Continue to push down with the handle until
you feel the resistance of the food cease and
you cannot push any further.
6. Lift the handle back up and remove the cleaner
from the grid slots. Repeat the process if any
large pieces still remain.
NOTE
Any small food pieces remaining can be removed
by washing brush or rinsing in the sink.
18
Motor base
To clean the motor base, wipe with a soft, damp
cloth then dry thoroughly. Wipe any excess food
particles from the power cord.
Cleaning agents
Do not use abrasive scouring pads or cleansers
on either the motor base or the bowls, as they may
scratch the surface. Use only warm soap water
with a soft cloth.
Stubborn food stains and odours, strong smelling
foods such as garlic, fish and some vegetables
such as carrots may leave an odour or stain the
bowl or lid. To remove, pour warm soapy water
(do not overfill). Set aside to soak for 5 minutes,
without immersing the whole bowl. Then wash with
a mild detergent and warm water, rinse well and
dry thoroughly. Store the bowl with the lid off.
Advertisement
