Pyle PDWM94 User Manual

PDWM94
Professional Wired/Wireless Microphone
Includes Mic & Wireless Adapter Receiver
Please read this manual carefully before operating the
Professional Wired/Wireless Microphone system. This
manual covers the function and operation of the Mic
& Wireless Adapter Receiver.
System Operation
1. Screw o the housing, insert battery (size AA) with the
correct polarity and screw on the housing before
inserting the telescopic antenna and set the switch to
ON position. The pilot lamp is ON at this time. Insert
another battery (sizeAAA) into the receiver with the
correct polarity. Set the switch of receiver to ON
position, then the pilot lamp is on that indicates good
condition. After that, plug the receiver into the input
socket for microphone of ampli er and it is ready for
operation.
2. When you need temporary stop during singing and you don't want the microphone
to pick up any other sound,you may set the switch to the middle (MIC) position.
Now, the lamp is still ON but your microphone doesn't transmit any sound.
3. Use it as wired microphone: Take out the battery from the microphone, connect
the wire to the microphone and set the switch to MIC position.
ATTENTIONS:
1. If acoustic quality and volume is not normal or receiving distance is shorted, the
batteries in wireless microphone and receiver should be replaced, If there after
still not in normal operation, you can carefully trim the frequency of the receiver
with a screw driver to and check if it works normal operation.
2. If your microphone will not be used for a long period of time, the battery should
be taken out to avoid its deterioration and the damage of components.
3. You may use two wireless microphones at the same time.
www.PyleUSA.com