Advertisement
(2) Remove the microwave absorber ® and film @.
(5) Revers the above steps for reassembly.
(1) To reduce gap located on part 'A'.
1) Loosen two bolts and nuts. On top door
hinge stopper, then push the door to
contact the door seal to oven front
surface.
2) Tighten two bolts and nuts.
(2) To reduce gap located on part 'B'.
1) Loosen two bolts and nuts on under hinge stoppe, then push the door to contact the seal to
oven front surface.
2) Tighten two bolts and nuts.
(3) To reduce gap located on part 'C'. (See Fig. A)
1) Remove. the cabinet.
2) Loosen a screw on interlock switch assembly located bottom of oven body.
3) Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
4) Tighten a screw.
(4) To reduce gap located on part 'D' (See Fig. B)
1) Remove the cabinet.
2) Loosen a screw on interlock switch assembly located top of over body.
3) and (4) are same as step (3).
30
Advertisement
