ZyXEL Communications NWA-3160 Quick Start Manual page 14

Make sure the screws are securely fixed to the wall and strong enough to
hold the weight of the ZyXEL Device with the connection cables.
2 Adjust the cables.
Run the connection cables down the back of the ZyXEL Device as shown in the following
figure.
OR:
Run the connection cables upward and along the edge of the ceiling.
3 Align the holes on the back
of the ZyXEL Device with
the screws on the wall.
Hang the ZyXEL Device on
the screws.
5 Set Up Power over Ethernet (Optional)
Power over Ethernet (PoE) is the ability to provide power to your ZyXEL Device via an 8-
pin CAT 5 Ethernet cable, eliminating the need for a nearby power source.
A PoE injector (not included) is also needed to supply the Ethernet cable with power. This
feature allows increased flexibility in the location of your ZyXEL Device.
ENGLISH
14