Table of Contents
Advertisement
Electrical Configuration
• 208/240VAC circuit (voltage range +5/-10%)
• Dedicated 30-amp circuit: cord cap, receptacle, and breaker
• Machine is supplied with a power cord (PN 46908.0002) AWG 10/3 30A/250V with Plug L1, L2, G.
NOTE: (N) no neutral wire/conductor used.
• Receptacle within 4.5 feet (1.4 meters) of the machine. (Note: the length of the power cord is
regulated by the machine's UL certification; the length and type of cord cannot be substituted.)
• Machine total amp draw 24.0 amps at 208VAC
• Determine the available on-site electrical service.
Improper electrical installation will damage electronic components.
CAUTION:
1. An electrician must provide electrical service as specified.
2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3. Connect the dispenser to the power source.
4. If plumbing is to be hooked up later be sure the dispenser is disconnected from the power source. If
plumbing has been hooked up, the dispenser is ready for Initial Fill & Heat. (pg 14)
Power Cord, 10/3 30A/250V
Panel Strain Relief
Receptacle
L2
NEMA L6-30R
Voltmeter
L1 - L2 208VAC
L1 - G 120VAC
L2 - G 120VAC
INITIAL SETUP
EXAMPLE
GREEN
L1
RED
or
WHITE
G
7
BLACK (L1)
GREEN (Ground)
RED or WHITE (L2)
Plug
NEMA L6-30P
BLACK
Advertisement
Table of Contents
