Table of Contents
Advertisement
9.2
FIT drive system
The components of the drive system are checked
constantly and automatically. If an error is
detected, an error message appears on the
display. The drive may be shut off automatically,
depending on the type of error.
9.2.1
The drive system or display do not
start up
If the display and/or the drive system do not start up,
proceed as follows:
1 Check whether the battery is switched on. If
not, start the battery.
Contact your specialist dealer if the battery
level indicator LEDs do not light up.
2 If the LEDs on the battery level indicator light
up, but the drive system does not start up,
remove the battery.
3 Insert the battery.
4 Start the drive system.
5 If the drive system does not start up, remove
the battery.
6 Clean all the contacts with a soft cloth.
Symptom
Cause
Is the speed too high?
Is the battery charged sufficiently?
Assistance is not
The battery may become too hot during
available.
rides at high temperatures, up long
inclines or when carrying a heavy load
for a long time.
The rechargeable battery, display or
assistance switch may be connected
incorrectly, or one or more of them may
have a problem.
Are the pedals being pushed?
Is the system switched on?
Assistance is not
available.
Is the assistance mode set to [OFF]?
Table 125: Error solution for assistance system
MY23Z12 - 12_1.0_26.01.2024
Troubleshooting, fault clearance and repair
7 Insert the battery.
8 Start the drive system.
9 If the drive system does not start up, remove
the battery.
10 Fully charge the battery.
11 Insert the battery.
12 Start the drive system.
13 If the drive system does not start, press the
On-Off button (control panel) for at least 8
seconds.
14 If the drive system does not start after about
6 seconds, press the On-Off button (control
panel) for at least 2 seconds.
15 Contact your specialist dealer if the drive
system does not start.
9.2.2
Warning messages and LEDs
All warning messages and the meaning of the
different LEDs are explained in Section 6.2.
9.2.3
Errors in the assistance system
Remedy
1
Check on-screen indicators. The electronic gear assistance is only
active up to a maximum speed of 25 km/h.
2
Check battery is charged.
3
Recharge the battery if it is almost flat.
4
Switch off the drive system.
5
Wait a moment and then check again.
6
Contact your specialist dealer.
7
The pedelec is not a motorbike. Push the pedals.
8
Press On-Off button (battery) to switch on the system.
9
Set the assistance mode to a different level of assistance than
[OFF].
10 Contact your specialist dealer if you still feel that no
assistance is being supplied.
216
Advertisement
Table of Contents
