ZyXEL Communications NBG-419N Quick Start Manual page 9

1. Make sure your NBG-419N is turned on (A). Place
your wireless device within range of the NBG-419N.
2. Enable wireless on the NBG-419N by turning on the
WLAN switch (B).
3. Press the WPS button on the NBG-419N and your
notebook (C). It doesn't matter which button is
pressed first. You must press the second button
within two minutes of pressing the first one.
The WPS LED (
the WPS process, then shines steadily when the WPS
process is finished.
If your WPS connection is successful, you should
now be able to access the NBG-419N.
4. Connect the WAN port (D) on your NBG-419N to your
broadband modem. You are now ready to connect to
the Internet wirelessly through your NBG-419N.
If your wired Internet connection is fine but your
wireless connection is not, repeat step 3. If WPS
is not working or your wireless device does not
support WPS, go to the next section.
) on the NBG-419N blinks during
ENGLISH
9