Table of Contents
Advertisement
Disassembly
NOTE: All disassembly procedures assume that the system is turned OFF, and disconnected from any power supply (the
battery is removed too).
Maintenance Tools
The following tools are recommended when working on the notebook PC:
•
M3 Philips-head screwdriver
•
M2.5 Philips-head screwdriver (magnetized)
•
M2 Philips-head screwdriver
•
Small flat-head screwdriver
•
Pair of needle-nose pliers
•
Anti-static wrist-strap
Connections
Connections within the computer are one of four types:
Locking collar sockets for ribbon connectors
Pressure sockets for multi-wire connectors
Pressure sockets for ribbon connectors
Board-to-board or multi-pin sockets
2 - 2 Overview
To release these connectors, use a small flat-head screwdriver to gently pry
the locking collar away from its base. When replacing the connection, make
sure the connector is oriented in the same way. The pin1 side is usually not
indicated.
To release this connector type, grasp it at its head and gently rock it from
side to side as you pull it out. Do not pull on the wires themselves. When
replacing the connection, do not try to force it. The socket only fits one
way.
To release these connectors, use a small pair of needle-nose pliers to gently
lift the connector away from its socket. When replacing the connection,
make sure the connector is oriented in the same way. The pin1 side is usu-
ally not indicated.
To separate the boards, gently rock them from side to side as you pull them
apart. If the connection is very tight, use a small flat-head screwdriver - use
just enough force to start.
Advertisement
Table of Contents
