Troubleshooting - ZyXEL Communications P-792H Compact Manual

The following table describes the labels in this screen.
Table 6 Adding/Editing Source and Destination Addresses
LABEL
Address Type
Start IP
Address
End IP
Address
Subnet Mask

6 Troubleshooting

PROBLEM
None of the LEDs
turn on when you turn
on the Prestige.
Cannot access the
Prestige from the
LAN.
Cannot ping any
computer on the LAN.
Cannot access the
Internet.
Do you want your rule to apply to packets with a particular (single)
IP address, a range of IP addresses (e.g., 192.168.1.10 to
192.169.1.50), a subnet or any IP address? Select an option from
the drop down list box
Enter the single IP address or the starting IP address in a range
here.
Enter the ending IP address in a range here.
Enter the subnet mask here, if applicable.
Make sure that you have the correct power adaptor connected to the Prestige and
plugged in to an appropriate power source. Check all cable connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you
should contact your local vendor.
Check the cable connection between the Prestige and your computer or hub.
Ping the Prestige from a LAN computer. Make sure your computer Ethernet adapter
is installed and functioning properly.
If the LAN LEDs are all off, check the cable connections between the Prestige and
your LAN computers.
Verify that the IP address, subnet mask of the Prestige and the LAN computers are
in the same IP address range.
Verify the Internet connection settings in the WAN screen.
Make sure you entered the correct user name and password.
Prestige 792H
DESCRIPTION
CORRECTIVE ACTION
27