ZyXEL Communications P-792H Compact Manual page 14

Figure 6 Wizard Screen 1
If your Prestige is a server, then select the mode that applies to your
region: ANSI (American National Standards Institute) and ETSI
(European Telecommunications Standards Institute). If your Prestige
is a client, select the same Standard Mode that the server side
selects.
Step 2.
Click Next to go to the second Wizard screen.
Figure 7 Wizard Screen 2
Step 3.
The third wizard screen varies depending on what mode and encapsulation type you use.
All screens shown are with routing mode. Configure the fields and click Next to continue
or Back to go to the previous screen. See the first screen below, Internet Connection
with PPPoA, for explanations of the following fields: User Name, Password, IP
Address, Connection, and Network Address Translation.
Prestige 792H
Select Client if your Prestige will act as a
client device or Server if your Prestige
will act as a server.
If you enable Rate Adaption, the
Prestige will connect at the optimal
transfer rate between the min and max
rates below. If you disable Rate
Adaption, it will attempt to connect at
the maximum transfer rate configured. If
that rate can't be attained, the
connection will not be established. Next,
select transfer rates from the Max Rate
and Min Rate drop-down list boxes. For
LAN-to-LAN applications make sure that
your Prestige and its peer have the
same Transfer Max Rate and the same
Transfer Min Rate.
From the Mode drop-down list box, select
Routing (default) if your ISP allows multiple
computers to share an Internet account.
Otherwise select Bridge.
Select the encapsulation type your ISP uses
from the Encapsulation drop-down list box.
Choices vary depending on what you select
in the Mode field.
Select the multiplexing method used by your
ISP from the Multiplex drop-down list box.
Enter the correct Virtual Path Identifier (VPI)
and Virtual Channel Identifier (VCI) numbers
supplied by your ISP in the VPI and VCI
fields. These fields may already be
configured.
Click Next.
14