Table of Contents
Advertisement
Stopping
Cautions When Stopping
Do not stop the engine abruptly during high-speed operation or while engine is hot. Otherwise, the engine life will
be shortened. Except in a case of emergency, operate the engine in low idle for 5 to 6 minutes to cool the engine
befor stopping. And check the engine for abnormalities.
Do not race the engine immediately before shutdown.
Do not restart the engine immediately after abnormal stop. If the engine stops, setting off the alarm, be sure to
locate the cause of the problem and correct the problem before starting the engine again. After restarting the oper-
ation, check the engine for abnormalities again. If an abnormality is found, repair it immediately.
When stopping the engine by pressing the stop button, you do not need to keep pressing the button.
Stopping Procedure
1. Place the direction lever in the neutral "N" position.
2. Before stopping, run the engine at low idle for 5 to
6 minutes to cool the engine.
3. Press the engine stop button on the instrument
panel to stop the engine.
4. Turn the starter switch to the "OFF" position.
5. Turn the battery switch to the "OFF" position.
6. Close the Kingston valve.
STOP
Fig. 3-25 Engine Stop Button
O N
O N
OFF
OFF
BUZZER
ILLUMINATION
Fig. 3-26 Starter Switch "OFF"
Fig. 3-27 Battery Switch "OFF"
Chapter 3 OPERATION
OFF
HEAT
ON
START
STARTER SWITCH
OFF
3-19
Advertisement
Table of Contents
Troubleshooting
