Canon ELPH Z3 IXUS III Instructions Manual page 37

Setting the Custom Functions
Effects with the Function Set to 1_
Releases the shutter immediately when you press the shutter
button halfway down and then press it fully. Useful for
situations where you need an instant camera response. (-> 28)
Stores the flash mode in memory immediately before the
camera is switched off Useful when you always want to set
the flash to a particular mode, f—» 21
1
_
Useful for situations where you do not want the sudden sound
of the film rewinding. When you have reached the end of the
roll, "0" on the frame counter and
O
blink. Press the
button to start film rewinding t-> 12i _
A convenient function for when you want the subject of your
shot to be off the center (-» 24) or when you want to focus
definitely on your subject. The subject must be positioned in
the center of the AF frame.____
While the shutter button is pressed, you can take
approximately 0.8 continuous shots per second
v<§>
Set the function.
• Press the V<§> button to
change the setting display
to 1 (function enabled).
Press the J<§> button
again to change the setting
to 0 (function disabled).
• Turning the power on
completes the settings.
2
|^| • The Custom Functions were all set to zero (0) at the
factory setting.
• The Custom Function settings are retained even when
you switch the camera off and on, replace the film
cartridge, or replace the battery.
H-37