Table of Contents
Advertisement
E
Taking Pictures in Autoflash Mode
• Dust or soiling on the AF sensor or lens causes focusing
problems. Wipe soiled areas clean before taking pictures
• Do not push on the lens with your hand
• There is a very short delay between the shutter button
being pressed and the shutter releasing In general, you
should continue to hold the camera still until you hear
the sound of the film winding on, which indicates that
the shot has been taken
• In dark places, the AF-assist beam emitter (-> 6) will
light automatically.
• If the lens is left extended in the telephoto position and
is not used for 4 minutes, the lens is automatically
retracted to wide-angle position.
• You can use the CF1 Custom Function setting to set the
camera to Real-time Release mode, in which the shutter
is released instantly. (-> 28, 36)
• You can use the CF4 Custom Function setting to set
center-point AF <-> 36).
About the Shutter Button
The shutter button is a two-stage switch Lightly press the
shutter button halfway
to automatically determine focus
and exposure. Press again fully
to take the picture.
t
[1-17
Advertisement
Table of Contents
