Sears CRAFTSMAN 917.249392 Owner's Manual page 12

SUPTORT POST
ASSEMBLY
RETAINER
SPRING
REAR
MOUNTING
bracket
SUPPORT
BRACKET
PIN
FIGURE 10
5. Assemble the support post assembly to the rear
mounting bracket (Fig 10} using support bracket
pin and retainer spring Retainer spring shown full
size below. Support post Istch pin and retainer
spring furnished with bagger
6 Install end plug (Fig. 11) on elbow support tube. End
plug furnished with bagger.
7. Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 11) using: two form¬
ed washers and two 5/16 locknuts {shown full size
below}^ NOTE: Do not tighten. Elbow retainer,
elbow shield and hardware furnished with bagger.
ELBOW
retainer
8, Locate the hole in one end of the elbow. Slide this
end of the elbow through elbow retainer (Fig. 12 -
inset). Secure elbow to elbow retainer using: one
clip, one screv., two washers and one acorn nut
NOTE: Mount clip in hole located 2 ~ 1/2" from edge
of elbow Hardware shown full size below. Head of
screw and flat washer mount to the inside of elbow.
Position dip with closed end of clip facing tube open¬
ing as shown in Fig 12 - Inset Tighten securely.
NOTE: Tighten hardware assembled in step Z Elbow
and hardware furnished with grass catcher.
12