Sears CRAFTSMAN 917.249392 Owner's Manual page 11

16. Attach discharge guard to latch assembly and
mower housing (Fig, 8) using two 5/16 carriage
bolts and two 5/16 locknuts (shown full size
below). Bolt heads to underside of mower housing
Tighten securely. Hardware furnished with grass
catcher NOTE: Tighten hardware assembled in
steps 13 and IS.
1 7 Reattach mower to tractor. Refer to "Mower in-
stallatlon" In your tractor owners manual.
ASSEMBLY GRASS CATCHER
All hardware for grass catcher assembly Is found In bag
labeled "Mounting Bracket Hardware"
1 Locate u-bolt in parts bag. Place two 1/4 hex nuts
and two washers (shown full size below) on u-bolt
NOTE: Run nuts on u-bolt as shown in illustration below.
U-bo/t and hardware furnished with grass catcher.
2 Insert u-bolt through slot in drawbar as shown in
Fig. 9.
3. Place the rear mounting bracket (Fig. 9) an u-bolt
and secure with two washers and two 1/4 locknuts
(shown full size below). Tighten finger tight. Rear
mounting bracket and hardware furnished with
grass catcher
4 Secure the rear mounting bracket to the drawbar
(Fig. 9) using: one shoulder bolt, one washer and
one 3/8 locknut (shown full size below). Tighten
securely. NOTE: Tighten hardware assembled In
step 3, Hardware furnished with grass catcher
U-BOLT
SHOULDER
BOLT
11
FIGURE 9