Sears CRAFTSMAN 917.249392 Owner's Manual page 10

1 0. Place L.H. baffle (Fig. 4) on lip of mower housing.
Secure runner to L.H. baffle and mower hous¬
ing using: two 5/16 carnage bolts and two 5/16
locknuts (shown full size below) NOTE: Do not
tighten. L H baffle and hardware furnished with
bagger.
1 1 Using a 1/2" wrench remove hardware "D" (Fig.
5 - Inset) securing discharge guard to mower hous¬
ing. Hardware may be discarded.
1 2. Using a 1/2" wrench remove hardware "A", "B"
and "C" (Fig. 6) securing R.H. runner to mower
housing. Hardware may be discarded.
1 3 Place RM. baffle (Fig. 4) on lip of mower housing.
Secure R.H. runner to R.H. baffle and mower hous¬
ing using: one 5/16 carriage bolt and one 5/16
locknut (shown full size below) NOTE: Do not
tighten. R H baffle and hardware furnished with
grass catcher.
14. Secure L.H, baffie and R.H. baffle to mower hous¬
ing using: four clamps, four 1/4 hex bolts and four
1/4 locknuts (shown full size below). Clamps and
hardware furnished with grass catcher .
a. Place clamps (Fig. 7) over holes in L.H. and R.H.
baffles (Fig. 7). Bolt heads to underside of
mower housing. Tighten securely. NOTE:
Tighten hardware assembled in step 10
securely.
1 5 . Assemble latch assembly to top of R.H. runner (Fig.
8} using: two 5/16 carriage bolts and two 5/16
locknuts (shown full size below). Bolt heads to
underside of mower housing. NOTE: Da not tighten.
Latch assembly and hardware furnished with grass
catcher.
FIGURE?
10