Table of Contents
Advertisement
Electromagnetic immunity
The RadiForce series has been tested at the following compliance levels according to the testing requirements for profes-
sional healthcare facility environments defined in IEC / EN60601-1-2.
Customers and users of the RadiForce series must ensure that the RadiForce series is used in the following environments:
Immunity test
Test level for professional
healthcare facility
environments
Electrostatic dis-
±8 kV contact discharge
charge (ESD)
±15 kV air discharge
IEC / EN61000-4-2
Electrical fast tran-
±2 kV power lines
sients / bursts
±1 kV input / output lines
IEC / EN61000-4-4
Surges
±1 kV line to line
IEC / EN61000-4-5
±2 kV line to ground
Voltage dips, short
0 % U
T
interruptions and
0.5 cycles and 1 cycle
voltage variations on
70 % U
power supply input
25 cycles
lines
0 % U
T
IEC / EN61000-4-11
5 sec
Power frequency
30 A/m
magnetic fields
(50 / 60 Hz)
IEC / EN61000-4-8
Compliance level
±8 kV contact discharge
±15 kV air discharge
±2 kV power lines
±1 kV input / output lines
±1 kV line to line
±2 kV line to ground
(100 % dip in U
)
0 % U
(100 % dip in U
T
T
0.5 cycles and 1 cycle
(30 % dip in U
)
70 % U
(30 % dip in U
T
T
T
25 cycles
(100 % dip in U
)
0 % U
(100 % dip in U
T
T
5 sec
30 A/m
Electromagnetic environment - Guidance
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
)
Mains power quality should be that of a typi-
T
cal commercial or hospital environment. If the
)
user of the RadiForce series requires continued
T
operation during power mains interruptions, it
)
is recommended that the RadiForce series be
T
powered from an uninterruptible power supply or
a battery.
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical commercial
or hospital environment.
The product should be kept at least 15 cm away from
the source of power frequency magnetic fields during
use.
27
Appendix
Advertisement
Table of Contents
