Table of Contents
Advertisement
Other Play Methods
|
The letters such as @) in the various illustrations refer to the descriptions in the "Location of Controls" section (see page 2).
Skip play
The disc plays from the specific track through to the end, then
play stops automatically.
Preparation: Put unit in stop mode.
oni,
«NORMALY
©
RESUME 00 ¢ RANDOM
{ao Poo)
2
Select the desired track.
Pr
o H
5
©
Ww
Program play
.
Up to 24 tracks can be entered in the programmed sequence.
Preparation; Put unit in stop mode.
<NORMAD
©
T
wi a
Select the pa track.
N
9
Register in sequence.
(The indication "M" and the programmed sequence appear
on the display panel.)
MEMORY!
RECALL
©
Q
Repeat steps 2 and 3 to program all
the desired tracks.
Q3
m A
©
B To
program
the
same
track
in the
se-
quence more than once
ae step 3, press [MEMORY/RECALL] desired number of
if")
"È" is displayed
No more tracks can be programmed.
To confirm the contents of the program
Press (MEMORY/RECALL) while the disc is playing. (The
number of the programmed tracks appear on the display
panel in the sequence.)
To
delete
the
entire
programmed
se-
quence
Press [E POWER OFF].
Random play
-=b
©
RESUMES t berry
Clon fon)
—
2
©
*NORMAL>
©
RESUME It 8 RANDOM
(loo Poo)
f
For your reference:
®t is also possible to press | bj] while the unit is in stop status
to change the first track to be played. (All tracks are played
eventually, regardless of which is played first.}
® Program play is not possibla in the random mode.
Resume play
This function allows you to listen from the beginning of the track
where
play stopped
because
the unit was
powered
off (or
switched to stop status). It is useful when listening to CDs in the
car, atc,
„e
NORMAL
'RESUME A 1 1 RANDOM
©
m
NORMAL
©
RESUME 1 1 1 RANDOM
ELIE ELI
—r
For your reference:
*1f the [RESUME, NORMAL, RANDOM {play mode)] slider is put
in the [RESUME] position, the all-repeat function will be
activated automatically as soon as ihe unit is powered on.
sif power is cut off near the end of a track (power off status),
playback may resume from the beginning of the next track.
tf the unit is powered off while a disc was playing and then a
new disc is inserted, play wilt begin from the middle of the new
disc because
the unit remembers
the position where
play
stopped on the pravious disc.
Repeat function
Press during play or stop mode.
REP
The setting is switched in the sequence indicated below
each time [REP] is pressed.
1-track repeat (1 >)
Ops track is repeated:
All-track repeat (ALL œ>)
i the tracks on.the disc are repeated.
Cancel
For your reference:
If [REP] is pressed during program play, only the tracks
in the program are repeated.
(The indication "ALL" is not displayed.)
Changing the sound quality
Press during play or stop mode.
Rs
The setting switches in the sequence indicated below
each time [S-XBS] pressed.
S-XBS— Normal (no indicator is shown)
S-XBS:
Select this setting to boost the low-range response.
7)
Anti-Shock Function
Anti shock works by reading audio data and storing it in memory
(up to 40 seconds worth). The unit then fills in interruptions
caused by bumps and vibrations with data from the memory. This
unit also incorporates a powerful anti-shock mechanism that pre-
vents skipping caused whan play speed is changed by swinging
of the unit.
Press during play or stop mode.
A.SHOCK
The following indicator appears on the display panel.
See
If you have pressed [A.SHOCK] when the unit is in stop
status, press {> PI] to start play.
When bumps continue repeatedly
The following indicator appears on the display panel
and sound is interrupted.
e
To cancel the anti-shock function
Press [A.SHOCK] again.
The anti-shock setting can be changed during play,
'but this may cause a slight interruption in the sound
because the disc's rotation speed changes.
@During anti-shock operation, the disc rotates at a high-
er rate than usual to collect extra audio data. This
could result in a slight increase in disc rotation noise.
Using the unit with an audio system
The anti-shock function uses digital signal compression
technology. It is recommended that the anti-shock func-
tion be canceled if the unit is connected to a home
audio system.
Advertisement
Table of Contents
