Alignment
11. Maximum Deviation
Note: The "TX VCO Tune Voltage" and "Modulation Balance" must be done before this alignment is started.
Set the transceiver to CH1 (band center, wide devia-
tion) via the "Channel" box on the "Alignment" win-
dow.
Click the left mouse button on the "Maximum Devia-
tion" button.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, until the deviation
meter reading is 4.2 kHz ± 0.1 kHz.
Press the "OK" button on the window, the value of the
alignment for Maximum Deviation (Wide Deviation)
will be saved in the radio.
G-12
Set the transceiver to CH 2 (band center, narrow de-
viation) via the "Channel" box on the "Alignment"
window.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, until the deviation
meter reading is 2.1 kHz ± 0.1 kHz.
Press the "OK" button on the window, the value of the
alignment for Maximum Deviation (Narrow Devia-
tion) will be saved in the radio.