Remote Control - Harman Kardon TU9600 Owner's Manual

harman/kardon
Stereo Tuner
Act Track Fine Tune Hi-Blend
Ant 1
P Scan
Co
Ant 2
Seek Tune Down
oOo
Oo
et
eal as
Memo
AM
=
Tune Up
os
O
fa
Shift
The remote control unit (for the TU9600
only) provides the identical functions
as the buttons on the front of your
tuner, with two exceptions.
1. The remote unit does not have a
Power switch. The tuner may be
turned on and off at the unit itself,
or it may be controlled remotely in
the following way:
(1) Plug the tuner's power cord into
a switched AC receptacle in your
preamplifier, integrated amplifier, or
other stereo component equipped
with its own remote control.
(2) Leave the tuner turned on.
(3) Turn the other component on
and off using its own remote control
unit. Tuner will turn on and off along
with the other component.
2. A Preset Scan ("P.Scan') button
appears on the remote control, but
not on the tuner itself. When
P.Scan is pressed, the unit tunes
successively to each of the preset
stations (in alphanumeric order) for
10 seconds each. To stop scan-
ning, press P.Scan again, and the
unit will remain tuned to the current
preset station. Or stop the scan
and tune to any desired station
using either the Shift and
numbered Preset buttons, or the
Tune Up and Tune Down buttons.
REMOTE CONTROL
The control unit operates effectively
within a distance of 7 meters (23 feet)
and within an angle of 30° from the
tuner. Using the control near fluores-
cent lights may shorten this range, as
will any dust or dirt that is allowed to
accumulate on the front end of the
remote control, or the "Remote
Sensor' area of your tuner. Also avoid
blocking the line of sight between
tuner and remote.
Remote Sensor
aan
7 meters
(23 feet)
Operable Range
The control unit is powered by two AA
batteries, included with your tuner.
When you replace weak batteries,
replace both at the same time. When
the remote is to be unused for an
extended period, remove the batteries
to prevent damage from corrosion.
If you wish to control your TU9400/
TU9600 with an external infrared
remote sensor, simply connect the
wire from the remote sensor to the
REMOTE IN jack on the back panel. A
control wire may then be run from the
REMOTE OUT jack to the Remote
Input of another stereo component.
Alternatively, if you have a stereo
component with a built-in infrared
remote sensor and a Remote Output
jack, it may be possible to connect
this jack to the REMOTE IN jack of
your tuner. Not all components are
compatible, but it will not hurt to
experiment.
Once your TU9400 is connected to an
external infrared sensor, you will need
a compatible remote control com-
mander. One such commander is the
remote control unit from Harman
Kardon's TU9600 tuner, available
through Harman Kardon's Parts
Department.
Harman Kardon also offers Master-
works™ , a universal remote control
that can be used not only with your
tuner, but with other components as
well, including TVs, VCRs, Cassette
Decks and CD Players. Masterworks is
available from your Harman Kardon
dealer.