Table of Contents
Advertisement
en Rinse aid system
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
16 - 20°E.
Rinse aid system
12 Rinse aid system
You can use the rinse aid system
Rinse aid system
and rinse aid to get tableware and
glasses rinsed perfectly without
marks.
12.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
32
and lift
2
1
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
12.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press
.
1.
Hold programme button A and
2.
press
repeatedly until the dis-
play shows H:xx.
Release programme button A and
3.
.
a Programme button A flashes and
the display shows H:04.
Press programme button A re-
4.
peatedly until the display shows
the value set at the factory r:05.
Press programme button C re-
5.
peatedly until the right amount of
rinse aid has been set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
max
Advertisement
Table of Contents
