Ricoh Pro C7500 Safety Information Manual page 22

Notes to USA Users of FCC Requirements
Part 15 of the FCC Rules.
Note
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Supplier's Declaration of Conformity
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Responsible party: Ricoh USA, Inc.
Address: 300 Eagleview Boulevard, Suite 200 Exton, PA 19341, U.S.A.
Telephone number: 610-296-8000
Product Name: Printer
Model Number:
• Pro C7500
• Pro C7500H
Using the Shield Cable
Properly shielded and grounded cables and connectors must be used for connections to a
host computer (and/or peripheral) in order to meet FCC emission limits.
Notes to Canadian Users of Wireless Devices
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's licence-exempt RSS(s). Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules as this
equipment has very low levels of RF energy.
Remarques à l'attention des utilisateurs canadiens d'appareils sans fil
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d'Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
1. L'appareil ne doit pas produire de brouillage;
2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Cet équipement est conforme aux limites d'exposition aux rayonnements énoncées
pour un environnement non contrôlé et respecte les règles d'exposition aux fréquences
radioélectriques (RF) CNR-102 de l'ISDE puisque cet appareil a une niveau tres bas
d'energie RF.
20