Table of Contents
Advertisement
3 Alignments and Adjustments
3-2 Factory Mode Adjustments
3-2-1 Entering Factory Mode
To enter 'Service Mode' Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
Power OFF
3-2-2 How to Access Service Mode
Using the Customer Remote
1.Turn the power off and set to stand-by mode
2.Press the remote buttons in this order; POWER OFF-MUTE-1-8-2-POWER ON to turn the set on.
3.The set turns on and enters service mode.
4.Press the Power button to exit and store data in memory.
- If you fail to enter service mode, repeat steps 1 and 2 above.
5.Initial SERVICE MODE DISPLAY State
1.Calibration
2.Option Byte
3.White Balance
4.W/B Movie
5.Calibration Target
6.Calibration Value
7.MST3388
8.X242
9.X242 NTSC
10.FBE2
11.Sound
12.Dynamic Contrast
13.Checksum 0x0000
14.Reset
6. Buttons operations withn Service Mode
KEY
MENU
DIGIT
TV/VIDEO
3-2
MUTE
1
T-SC37AUSC-1004
T-SC37AUSM-1002
ACL 28.20.2.1
RFS:T-SC37AUSC-20070228
2007-03-05
DTP-LO-0022
FUNCTION
Item selection by moving the cursor
Data Increase/Decrease for the selected Item
Save set Data to EEPROM and go upper mode
Change channel
Change AV mode
8
2
Power On
Advertisement
Table of Contents
