Table of Contents
Advertisement
Remote Control Programming & Operation
This product is equipped with a powerful
remote control. As supplied, it will oper-
ate the unit, as well as most tuners, CD
players and tape decks manufactured by
Harman Kardon. In addition, it is pre-
programmed with the remote codes to
operate VCRs, LD players and TV sets that
are based on the popular RC-5 control
code system. If your equipment requires
different codes, it may be programmed to
copy the codes from most infra red
remotes.
Loading Batteries
The life of the batteries for the remote
control is about one year in normal oper-
ation. If the green Sending @ indica-
tor does not flash when remote buttons
are pushed, that is an indication that the
batteries need to be replaced. The batter-
ies should be removed if the remote will
not be used for an extended period of
time.
To change the batteries:
1. Remove the back cover by sliding it in
the direction of the arrows.
2. Remove the old batteries and insert
fresh AAA type cells. Be certain to observe
the correct polarity by noting the (+)
and (—) marks on both the inside of the
case and on the battery cells. It is recom-
mended that both batteries be changed at
the same time.
13
\ =)
Ne
°o
a
3. Close the cover until it clicks shut.
NOTE: It is important that the batteries
be replaced within ten minutes after the
old batteries are removed to avoid losing
any remote codes that have been pro-
grammed into the remote's memory.
Remote Control Range
The remote will operate at a range of up
to 5 meters from the unit, when the bat-
teries are fully charged. The remote will
also operate at an angle of up to 30° to
either side of the unit.
Always point the remote transmitter at
the front of the unit when issuing com-
mands. If you find that remote com-
mands are not being received by the
remote, it may be necessary to use a
remote IR sensor.
HSI19
Remote Programming
Programmable Keys
Most of the buttons on the remote control
that may be user programmed to new
functions to operate virtually any compo-
nent in your system. Ten CANNOT be
programmed with a new code, as they
control high level functions of the AVI
250. These keys are Main Power ON,
Main Power OFF, and the eight source
input keys: TV, LD, VCR 1, VCR2,
TUNER, CD, TAPE 1 and TAPE2.
Programmable keys are divided into two
groups. Some keys may be programmed
with a separate function for each of the
inputs. Thus, these keys may change
their code when the input source is
changed. (ie. The Play key may trans-
mit a different code when CD is selected
as opposed to when VCR is selected.)
The keys that may be programmed with
multiple codes are the following:
All Numeric Keys (0 - 9)
Forward Play i=
Source Power On
Reverse Play
Source Power Off
Stop @
Disc/Deck ++
Record @
Disc/Deck —
Pause |]
Channel/Skip me
TV Volume Up &
Advertisement
Table of Contents
