Front Panel Information Display - Harman Kardon AVI 250 Owner's Manual

Front Panel Information Display
@ "Visual" Indicators: These indi-
cators display which input source is
being fed to the video monitor output.
@ Test: This indicator flashes when
the output levels are being set using
the built in test signal generator.
© Volume Indication: The last two
indicators on the information display
indicate the volume level. Note that
OdB is the reference level, not an
indication that there is no output.
© Main Information Display: This
ten digit display shows messages
relating to the status, input source,
surround mode, tuner, volume level
or other aspects of the unit's opera-
tion.
@ DISPLAY: This indicator lights
when the FL display has been
turned off using the Display button
to remind you that the unit is stilt
turned on.
5
@ Multi: This indicator signifies that
the unit is sending a program source
to a remote room location. Note that
it may be illuminated even when the
unit is "off" in the main listening
room, signifying that operation con-
tinues at another location. When a
remote command is being received
via the Multi IR connection, this indi-
cator will flash.
@ Copy Indicators: The TAPE
COPY indicator lights when an input
other than the current source has
been selected to copy Tape 1. The
VCR COPY] indicator signifies that
the input to VCR 1 is other than the
currently selected source.
@ Mode Status: These indicators
display the currently selected
surround mode.
HSITS