Door Reversal Instructions - Hamilton Beach HBFRF1010-3BCOM Owner's Manual

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any length of time during this
process, it must be allowed to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove both leveling legs located at the front of the cabinet. See figure A.
2. Remove the screws holding the lower hinge assembly to the cabinet. See
figure A.
3. Remove the door from the cabinet by lifting the door slightly and then
pulling downward.
4. Using a flat head screwdriver, remove the upper hinge pin from the worktop
and install it on the opposite side of the cabinet. See figure B.
5. Remove the hole plug from the top left side of the door and the bushing
from the top right side of the door and swap their positions. Do the same with
the hole plug and bushing on the bottom of the door. See figure B.
6. Install the door on the cabinet. Ensure that the top of the door is level with
the top of the cabinet and that the rubber gasket makes a good seal with the
cabinet all the way around.
7. Install the lower hinge assembly on the opposite side and then install both
leveling legs.
A
B