Onkyo TX-SR501 Instruction Manual page 4

Pre ca utio n
SmContinued
1. Recording Copyright Unless it's for personal use only,
recording copyrighted material is illegal without the permission
of the copyright holder.
2. AC Fuse The AC fuse inside the TX-SRhO l/TX-SRhO1E is
not user-serviceable, if you cannot turn on the TX-SRh01/
TX-SRh01 E, contact yoLirOnkyo dealer.
3. Care Occasionally you should dust the TX-SRh01 /
TX-SRh0I E all over with a soft cloth. For stubborn stains, use
a soft cloth dampened with a weak solution of mild detergent
and water. Dry the TX-SRhOI/TX-SRhO IE immediately afte>
wards with a clean cloth. Don't use abrasive cloths, thinners,
alcohol, or other chemical solvents, because they may damage
the finish or remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary fiom country to coLintry. Make sure that the
voltage in your area meets the voltage requirements printed on the
TX-SRh01/TX-SRh01E's rear panel (e.g., AC 230 V, 50 Hz or AC
120 V, 60 Hz).
The Worldwide model has a voltage selector for compatibility with
power systems around the world. Before you plug in this model,
make sure that the voltage selector is set to the correct voltage for
your area.
Setting the [STANDBY/ON] switch to STANDBY does not frilly
shutdown the TX-SRh01/TX-SRh01E. if you do not intend to use
the TX-SRh01/TX-SRh0 IE for an extended period, remove the
power cord from the AC outlet.
Memory backup
The TX-SRh01/TX_SRh01E uses a batterydess memory backup
system in order to retain radio presets and other settings when it's
unplugged or in the case of a power failure. Although no batteries
are required, the TX_SRh0 I/TX-SRh01E must be plugged into an
AC outlet in order to charge the backup system.
(On non-North American models, the TX-SRh01/
TX-SRh01E's POWER switch must be set to ON in order to
charge the backup system.) Once it has been charged, the
TX-SRh01/TX-SRh01E will retain the settings for several
weeks, although this depends on the environment and will be
shorter in humid climates.
Supplied Accessories
Make sure you have the following accessories:
_ % Only supplied in certain countries, Use
this adapter if your AC outlet does not
Indoor FM antenna match with the plug on the TX-SRh01/
(connector type varies from TX-SRh01E's power cord, (Adapter var-
AM loop antenna country to country) Power-plug adapter ies from country to country.)
Not supplied with North American and
European models.
75/300-ohm antenna
adapter
Remote controller & Speaker cable labels
two batteries (ANR6)
* In catalogs and oi_ packaghlg, the letter added to tbe end oftbe product nmne hldicates tbe color ofthe TX-SRh0 UTX-SRh01E. Spedfications and operation
are tbe same reg_v:dless o f color.
Features
4
Amp
• 6-channel amplifier
• 65 watts per channel into 8 ohms, 20 H_20 kHz with less
than 0,08% total harmonic distortion
• WRAT (Wide Range Amplifier Technology)
• Optimum gain volume circuitry
AudioNideo
• Dolby *l Digital EX and Dolby Pro Logic li
• DTS, DTS-ES Matrix/Discrete 6.1, and DTS Neo:6 pro-
.
*2
cessmg
• Cinema Filter function
• Advanced 24-bit DSP chip (5 DSP soundfields)
• Linear PCM 96 kHz/24-bit D/A converters on all channels
• Adjustable crossover (60, 80, 100, 120, 150 Hz)
2 component video inputs, 1 output
4 S-Video inputs, 2 outpms
3 assignable digital inputs (2 optical, 1 coaxial)
Subwoofer pre out
Color-coded multi-channel inputs
Color-coded speaker terminal posts (SPEAKERS B use
push-type terminals)
FM/AM Tuner
• 30 FM/AM presets
• FM auto tuning
• RDS (Radio Data System) (Europe only)
* 1. Manufactured under license from Dolby Laboratories. "Dolby," "Pro Logic," Surround EX," and the double-D symbol are trademarks of Dolby Laborato-
ries.
*2. "DTS," "DTS-ES Extended Surround," and "Neo:6" are trademarks of Digital Theater Systems, Inc.