Electrolux EWM09311 Service Manual page 36

Selector
position
TC 3-2
- Door safety interlock
5
- Third solenoid valve
TC 4
TC 3-2
- Door safety interlock
6 - Fourth solenoid valve
TC 4
(hot water where featured)
TC 3-2
- Door safety interlock
- Wash solenoid valve, if the
water in the tub is not enough
to cover the heating element
7
- Heating element
TC 4
- Weight sensor (if there is one,
an extra litre of water is
loaded)
- Circulation pump
TC 3-2
- Door safety interlock
- Wash solenoid valve, if the
water in the tub is not enough
8 to cover the heating element
TC 4
- Motor (55 rpm clockwise,
55 rpm anti-clockwise,
250 rpm pulse)
TC 3-2
- Door safety interlock
- Drain pump
9
TC 4 - Motor up to 650 rpm then at
maximum spin speed (**)
10 -----
Technical Support - DMM
Components activated
-----
Working conditions
Door closed
Water level below
anti-flooding level
Maximum time 5 min.
Door closed
Water level below
anti-flooding level
Maximum time 5 min.
Door closed
Water level above
the heating element
Maximum time
10 min. up to 90°C (*)
Door closed
Water level above
the heating element
Door closed
Water level lower
than anti-boiling level
for spinning
-----
36/124
Function tested LCD display
Water level
in the tub is
Water fill to third
displayed (mm)
solenoid valve
compartment
Water fill to fourth
solenoid valve
Water level
compartment
in the tub is
displayed (mm)
Reheating
Temperature
Circulation
in °C measured
using the NTC
probe
Check for leaks
from the tub
Drum speed
in rpm/10
Drain, calibration
of analogue
pressure switch
Drum speed
and spin
in rpm/10
-----
599 75 58-67 Rev.04
-----