Table of Contents
Advertisement
• Sensor no. 3: SPIN SPEED
This is related to the part of the LCD display in which the washing
cycle spin speed is shown.
The starting speed shown on the LCD display is the one set for the
programme selected.
Touch the sensor (represented by the spin cycle symbol) in sequence
to lower the speed; once the lowest speed has been reached, the next
selections are:
"Rinse hold" and the related symbol lights up
compatible with the chosen programme, and it also lights up
during the "Extra silent" programme in the washer-dryer).
"Night cycle" and the related symbol lights up
in the washer-dryer).
The next selection will be the highest speed available for the
programme.
The spin speeds are: 1,600–1,400–1,200–1,000–800–600–400–0
"No spin", "Rinse hold" and "Night cycle"
When no speed is selected, or one of the following cycles is selected:
"No spin", "Rinse hold" and "Night cycle", the LCD display shows
three dashes
• Sensor nos. 4-5-6-7: OPTION (configurable)
Each of the sensors located on the right hand side of the LCD display
can be combined with a LED and are used to choose one of the following
options:
Delayed start
Super rinse
Easy Iron
Pre-wash
Hot and cold water (only TC3 WM where featured)
Automatic drying (washer-dryer only) (see options)
Time-controlled drying (washer-dryer only) (see options)
Depending on the option/choices, the programme duration time is updated
(via the three digits).
• Sensor nos. 8-9
These two sensors are positioned under the display and act as:
Time manager
Allowing the end user to lengthen or shorten the washing cycle duration,
this adjustment should be done after setting the temperature value and
the spin speed.
• Sensor no. 10
This sensor has the START/PAUSE function, used to start up a washing
programme, after selecting the washing cycle and required options; it can
also pause a cycle that has already started: to allow you to change
selected option or open the door (if the temperature conditions or water
level allow for this).
The cycle re-starts if you touch the sensor again.
The LED combined with this sensor flashes slowly: in the selection phase,
during the pause and at the end of a cycle with water in the tub.
It stays lit when a cycle is running and turns off when the cycle has ended
and the door is unlocked.
While other sensors when touched immediately change from selected to
de-selected, in the case of this sensor, more time is needed to avoid
unwanted cycle start ups or pauses.
Technical Support - DMM
.
(where
(not available
27/124
S3
S4
S6
S7
S5
S8
S9
S10
599 75 58-67 Rev.04
Advertisement
Table of Contents
