Electrolux ETB3440M-H User Manual page 14

14 www.electrolux.com
4. Check the alignment of the refrigerator to
the surrounding cupboards to see if it is
level. You can adjust the level as detailed in
step 2 and 3.
aligned to
cupboards
ie. even gap
5. If you find your refrigerator rocks from
corner to corner, it means your floor is
uneven. Find a piece of plastic or
hardboard etc. and pack it firmly under the
roller.
6. You may now need to fine-tune the
installation by repeating steps 3, 4 and 5.
7. When you have the appliance in its final
position, it needs to be stabilised. Wind the
stability foot under the door hinge down to
the floor until it just makes contact with the
floor. Lift the front of the appliance to take
the weight off the stability foot, then turn it
half a turn further to ensure firm contact
with the floor. Wind the large height
adjusting nut back up to ensure all the
weight is now on the front stability foot.
Wind the large height adjusting nut back
up to ensure all the weight is now on the
front stability foot.
8. Repeat step 7 for the stability foot on the
handle side. Whenever you need to move
the appliance, be sure to wind the feet
back up so that the appliance can roll
freely and be sure to reset it when
reinstalling.
9. Plug your refrigerator straight into its own
power point and never use a double
adapter. If you need to roll the refrigerator
to get to the plug, remember to raise the
stability foot first.
10. Before you put any food in your refrigerator,
it's recommended you leave it on for 2 or 3
hours to check it is running properly.
top of refrigerator is
level ie. horizontal
adjust front feet for
uneveness of floor
eg. wind this foot
down or up