For More Information - Paradyne Hotwire 6390 Installation Instructions Manual

4.
CONNECT TO PC OR ETHERNET HUB. Use an 8-pin Ethernet cable
(straight-through or crossover) for the Ethernet connection. Insert one end of the
cable into the jack labeled ETHERNET.
Connect to one of the following:
— PC. Use an Ethernet standard,
straight-through cable and connect
the other end to a PC with an
Ethernet Network Interface Card
(NIC) installed.
– or –
— Ethernet Hub. Use an Ethernet
standard, straight-through cable and
connect the other end to an Ethernet
hub's Uplink port. (To connect to a
hub's standard port, use an Ethernet
crossover cable).
5.
CONNECT TO POWER. Insert the supplied power cord's
round end into the jack labeled POWER. Plug the
transformer into an AC outlet.
When the power cord is installed, the ReachDSL modem
goes through a power-on self-test.
The ReachDSL modem hardware installation is now complete.

For More Information

For more information about the Hotwire 6390 ReachDSL Modem, including front panel
LED status, troubleshooting, cabling, command line interface, downloading, and
technical specifications, please refer to the
Inline Phone Filter, Installation and Operation
Number 6390-A2-GK40. This document is available online at www.paradyne.com.
Select Library Technical Manuals
PC with Ethernet
Network Interface
Card
Ethernet
8
Hotwire ReachDSL Modem, Model 6390 with
Supplement, Document
Hotwire DSL Systems
4
Ethernet
Straight-through
Cable
Hub
1
2
3
4
5
6
7
Ethernet
Straight-through
Cable
POWER
Transformer
.
ETHERNET
ETHERNET