Installing The Hotwire 6310 Reachdsl V1 Modem - Paradyne 6310 Installation Instructions Manual

Installing the Hotwire 6310 ReachDSL v1 Modem

Place the ReachDSL modem on a flat surface with clearance for the rear connectors.
Procedure
1. If a telephone is connected at the RJ11
wall jack where the modem will be installed,
unplug the telephone line from the wall jack.
2. Connect a telephone to the modem.
(Optional – go to
connecting a telephone to the ReachDSL
modem.)
Plug the existing telephone interface cable
that was unplugged in
labeled PHONE.
3. Use the supplied RJ11 6-pin interface cable for the LINE connection. Insert one end
of the cable into the jack labeled LINE. Insert the other end of the cable into the
RJ11 wall jack.
NOTE:
If you are installing a POTS splitter with another telephone, connect the
telephone to the jack labeled PHONE, then connect the jack labeled LINE to a
wall jack. Do NOT plug any cable into the POTS splitter jack labeled either
MODEM or DSL. In particular, make NO connections between a POTS splitter
and the modem.
Step 3 if you are not
Step 1 into the jack
PHONE
RJ11
6-pin
Interface Cable
LINE
RJ11
Wall Jack
01-17015
5
RJ11
Wall Jack
01-17015a