Icom GM1600DU Instruction Manual page 11

D Battery pack
To remove the battery pack:
Turn the lock screw counterclockwise, then pull the battery
pack in the direction of the arrow as shown below.
To attach the battery pack:
Insert the battery pack into the IC-GM1600 completely, then
turn the lock screw clockwise.
NEVER remove or insert the battery pack when the trans-
ceiver is wet or soiled. This may result in water or dust
getting into the transceiver and battery pack, and may re-
sult in them being damaged.
NOTE: When the lock screw does not easily turn (feels
tight), check to ensure the battery pack is correctly in-
DO NOT
serted to the transceiver.
pact the battery, as this may damage the battery pack or
the transceiver.
Screw position for removing
OPEN
Screw position for attaching
OPEN
SUPPLIED ACCESSORIES AND ATTACHMENTS
strike or otherwise im-
BE CAREFUL!: The latch is tightly locked, so use caution
when releasing it. DO NOT use your fingernail. Use the
edge of a coin or screwdriver tip to carefully release it.
CAUTION!:
When attaching or removing a battery pack, make sure
the rubber seal is set in the groove of the battery pack
correctly. If the seal is not neatly in the groove it may be
damaged when attaching the battery pack.
If the seal is damaged, waterproofing is not guaranteed.
NOTE:
When attaching a battery pack, make sure dust or else does
not adhere to the rubber seal. If dust or anything else is on
the seal when attaching a battery pack, the water resistant
seal may be compromised.
Make sure both the rubber seal (purple) is correctly set into
the groove and dust or else does not adhere to it.
Correct position
Rubber seal
Groove
Battery pack
2
Incorrect position
Battery pack
2
3