Checking The Distance And Bearing To A - Casio 5635 Operation Manual

Checking the Distance and
Bearing to a Location
Memory Point (Location
Indicator)
The watch acquires current location
information from the phone, and then displays
the bearing and distance from your current
location to the location recorded in Location
Memory.
Recording Your Current Location (Location
l
Memory)
Memory point
Bearing to memory point
Distance to memory point
Important!
Note that CASIO WATCHES
●
operation is disabled while Location
Indicator is in use.
1. Y
Tap the "CASIO WATCHES" icon.
2. X
Enter the Timekeeping Mode or
Compass Mode.
Navigating Between Modes
l
Operation Guide 5635
3. X
Hold down (C) for at least two seconds
until [INDICATE] starts to flash. Release
the button when the second hand moves
to [READY].
When a connection is established
between the watch and phone and
location information acquisition is
successful, [INDICATE] will change to
[OK], and the second hand will move from
[READY] to [CONNECT].
After two seconds the distance from your
current location to the recorded location
will appear on the display, and the second
hand will indicate the bearing to the
destination.
Second hand
Bearing to destination
*
1
Distance from your current
location
*1
When the second hand is within the range
between 55 seconds to 05 seconds
(indicating that you are within 30 degrees
of the bearing to the destination), [
be displayed as a light figure on a dark
background.
*2
[G] is shown on the display when you are
within 80 meters of the destination. [G] will
disappear from the display if you move to
a distance of 161 meters or more from the
destination.
4. X
Check the display distance and the
bearing to your destination on the display.
After two seconds
*
2
] will
Note
Location Indicator remains enabled for
●
three minutes.
The watch connects with the phone
●
and acquires location information
every 10 seconds or each time (B) is
pressed, and uses the information to
refresh the distance and the bearing to
the point stored in Location Memory.
Location Indicator will become
●
disabled automatically about three
minutes after it is enabled. You can
also disable it manually by pressing
any button besides (B) or (L).
Pressing (B) or (L) while Location
●
Indicator is enabled will cause it to
remain enabled for three minutes after
the button is pressed.
Pressing (B) to update data causes [
●
TRY] to appear on the display and
remain displayed until data updating is
complete.
[ FAIL] will appear on the display in
●
the cases below.
When it has been 30 seconds or
ー
more since the last update and
location information acquisition fails
When it has been 60 seconds or
ー
more since the last update
When data acquisition fails after you
ー
press (B)
The display range for the distance to a
●
destination is 0 to 99,999 meters (0 to
327,995 feet). [ -----] will be shown
for the distance to the destination when
it is outside the display range.
[ERR] will appear on the display if
●
connection fails for some reason.
The message [NO-DATA] will appear
●
when there is no data in Location
Memory.
[FAILED] [POSITION] will appear in
n
●
sequence if the first location
information acquisition fails.
[ ] or [G] will flash on the display if the
●
watch detects abnormal magnetism
while Location Indicator is in use.
[ ERR] will appear on the display if a
●
direction sensor error occurs while
Location Indicator is in use.
12