Screen Menu Options; Auto Adjustment; Adjusting Horizontal/Vertical Position; Picture Phase Adjustments - Zenith P42W24B Installation And Operating Manual

Screen Menu Options

Auto Adjustment (RGB1 (PC) mode only)
Auto Adjustment (RGB1 (PC) mode only)
- Automatically adjusts picture position and minimizes image shaking.
- If the image is still not correct, your Monitor is functioning properly but needs further adjustment.
1. Press the AUTO CONFIG. button to run Auto configure.
• If the position of the image is still not correct, try Auto adjustment again.
2. If picture needs to be adjusted more after Auto adjustment in RGB1 mode, you can
manually adjust the image's
Adjusting Horizontal/ V
Adjusting Horizontal/ V
- You can only adjust
V-POSITION/H-POSITION
RGB1 (PC) modes.
1. Press the MENU button and then use
2. Press the G button and then use
G
3. Press the button and then use
G
4. Press the button and then use the
desired horizontal or vertical position.
• The adjustment range of
• The adjustment range of
• Based on the PC resolution, the adjustment range of
change.
• Based on input signal, the position of the picture may not change even though you
have adjusted the horizontal or vertical position with this function.
5. Press the MENU button.
Picture Phase Adjustments (RGB1 (PC) mode only)
Picture Phase Adjustments (RGB1 (PC) mode only)
- If the picture isn't clear after auto adjustment and especially if characters are still jittery, adjust the picture phase
manually.
1. Press the MENU button and then use
G
2. Press the button and then use
G
3. Press the button and then use
G
4. Press the button and then use the
• The adjustment range of
5. Press the MENU button.
Initializing (Reset to original factory value)
Initializing (Reset to original factory value)
- To initialize the adjusted value, select
then press the G button.
18
V-POSITION / H-POSITION
ertical Position
ertical Position
in DTV (480p,720p,1080i), COMPONENT (480p,720p,1080i), or in
D / E button to select the SCREEN menu.
button to select
D / E
D / E button to select
F / G
button to make adjustments until you get
V-POSITION is -50 ~ +50.
is -100 ~ +100.
H-POSITION
D / E button to select the SCREEN menu.
button to select
D / E
D / E button to select
F / G
button to adjust phase.
is 0 ~ 63.
PHASE
RESET with the D / E
and PHASE .
.
SCREEN ADJ.
V-POSITION or H-POSITION
V-POSITION/H-POSITION may
SCREEN ADJ. .
PHASE .
button in step 3 of 'picture phase adjustments' and
SCREEN
SCREEN ADJ. G
TO SET
VGA MODE
ARC
.
PIP/DW
ZOOM
SCREEN ADJ.
AUTO CONFIG.
0
V-POSITION G
H-POSITION
PHASE
RESET
SCREEN ADJ.
AUTO CONFIG.
V-POSITION
H-POSITION
G
PHASE 30
RESET