Zenith L20V26C Installation, Setup & Operating Manual page 37

Selecting the Second
Selecting the Second
If available on program, on-screen display in stereo mode: STEREO
If available on program, on-screen display in bilingual mode: SAP
- Sound heard from speakers based on mts selection:
This signal contains the secondary language signal in addition to the primary language.
There are primary and secondary language and stereo modes in bilingual signals.
[MONO]: The primary language is heard from left and right speakers in mono sound.
[STEREO]: The primary language is heard from left and right speakers in stereo sound.
[SAP]: The secondary language is heard from both left and right speakers in mono sound.
1 Press the mts button on the remote control.
Use the mts button to change the audio mode.
2
Each press of mts button changes the audio mode as
shown below.
Mono Stereo
3
A
Press the enter (
- Select Mono sound mode if the signal is not clear or in poor signal reception areas.
- STEREO and SAP modes are available only if included on the broadcast signal.
206-3921
Audio Program
Audio Program
SAP
) button to save.
37