Table of Contents
Advertisement
LOG #2: The short side of the Y on Log #2 will sit between log pins D and E, the long end of the Y will sit against log pin C.
The opposite end of Log #2 will sit on the air scoop. See Figure 20.
LOG #3: With the burnout facing left, place the big end of Log #3 against log pin F and slide back until it contacts log pin
G as shown in Figure 21. The small end will sit on the flat spot of Log #2. The front edge of Log #3 directly above Log #2
should measure 4 inches from the rear of the firebox when no liner kit is installed and should rest on Log #2. The front edge
of Log #3 directly above Log #2 should measure 3-3/8 inches from the rear refractory when a refractory kit is installed and
should rest on Log #2.
C C
Figure 20 Log #2 Installed
LOG #4: Set the non-Y end of log 4 on the flat spot of Log #1. The end of Log #4 will sit flush with the back of Log #1. The
Y-end of Log #4 will sit on the flat spot of Log #2. See Figure 22.
LOG #5: The non-burnout end of Log #5 will sit on the flat spot of Log #3. The corner of the other end will sit on the base
refractory grout line. See Figure 23.
LOG #6: Slide the burn out end of Log #6 between log #5 and log #3. Push the log back until it touches the firebox. The left
side will touch pin H. The right side of the log touches Log #3. The log should lay flat on the burner and the front refractory.
See Figures 24 and 25.
1 1
4 4
Figure 22 Log #4 Installed
Figure 24 Log #6 Installed - Natural Bark Logs
Heat & Glo • SUPREME-I25/30/35-IFT, SUPREME-I25/30/35-BIR, SUPRM-I30LP-IFT Installation Manual • 2532-980 Rev. AD • 3/24
46
2
2
D D
2
2
H H
5 5
3
3
6 6
Figure 21 Log #3 Installed
Figure 23 Log #5 Installed
Figure 25 Log #6 Installed - Birch Logs
3 3
2
2
G G
F F
5 5
3
3
H H
5 5
3 3
6 6
2532-935H
Advertisement
Table of Contents
