Heat & Glo SUPREME-I25-IFT Installation Manual page 42

LOG #2: Set Log #2 on the burner between pins B and C. Rotate the log counter clockwise until it contacts both pins B and
C and slide it back until it contacts the Air Scoop. Ensure Log #2 is not covering any ports. See Figure 4.
C C
2 2
SHOULDER SCREW
Figure 4 Log #2 Installed
LOG #3: With the burnout of Log #3 facing left, line the big end up with the edge of the basepan and the firebox wall or
refractory. The small end will sit half on the end of Log #2 and half on the air scoop as shown in Figure 5.
LOG #4: The Y-end of Log #4 should sit on the flat spot of Log #2, the other end will sit on the flat spot of Log #1. See Figure 6
2 2
Figure 5 Log #3 Installed
LOG #5: Place the non-bark end of log 5 on the flat spot of log 3. The front right corner on the other end of log 5 will sit at
the intersection of the grout lines on the base refractory. See Figure 7.
Figure 7 Log #5 Installed
Heat & Glo • SUPREME-I25/30/35-IFT, SUPREME-I25/30/35-BIR, SUPRM-I30LP-IFT Installation Manual • 2532-980 Rev. AD • 3/24
42
AIR SCOOP AIR SCOOP
B B
3 3
5 5
3 3
GROUT LINE GROUT LINE
4 4
1 1
Figure 6 Log #4 Installed
2 2