Remote Control Programming To Control Other Products Remote Control Programming; Programming The Remote - Zenith Presentation H25E46DT Installation And Operating Manual, Warranty

Programming the Remote

Program the remote to control a variety of Audio/ Video devices
1
The device you want to program should be ON.
2
Refer to the brand programming codes on pages
50/51 to find the type and brand name of the device
you're programming. Make a note of the three-number
code—you'll need it soon.
3
Press and hold the PRG key. It's recessed so it doesn't
get pushed accidentally. When the indicator light turns
on, you can release the key.
4
Push the key with the name of the device you're pro-
gramming (VCR, CABLE, AUX, TV).
5
Using the NUMBER keypad, enter the three-number
code found on the chart on pages 50/51.
6
Press ENTER to save the code The indicator light will
flash three times and turn off if the code was accepted.
7
Point the remote at the device and push the POWER
key. The device should turn off. If not, try the other
codes listed and continue from Step 3.
Programming your Zenith remote will allow you to use one
remote to work up to 7 different devices, if all remote operat-
ing modes are programmed!
Not all devices will work with your Zenith remote control.
Mode / Product Compatibility
TV VCR CATV
TVs VCRs Cable Boxes,
Satellite Receivers
P A G E 4 6
AUX (AUX+1, AUX+2, AUX+3)
All products on pp 50 - 51
3
PRG
Indicator Light
CABLE
SURF
VOLUME
1
4
7
0
MENU
RECORD
REWIND
7
POWER
4
VCR AUX TV
FLASHBK MUTE
CHANNEL
VOLUME
CHANNEL
2 3
5 6
5
8 9
6
ENTER
QUIT
TV/VCR
PAUSE
TIMER
SOURCE
PLAY
FFWD
STOP
206-4544 2/1/01