Auto Program - Zenith HealthView H20D50DT Installation And Operating Manual, Warranty

Auto Program (Channel Search)
Use Auto Program to specify Antenna or cable service
incoming signal source and automatically store all of the
channels that are found by channel search
1
With the Installer remote control in hand, press the
POWER key to turn on the HealthView TV.
2
Press the MENU key so the Setup menu appears.
3
Using SELECT on the remote control, highlight Auto
Program on the screen.
4
Press the Right or Left ADJ (Adjust) arrow to go to the
Auto Program menu.
5
Using SELECT, choose either Cable TV or Off Air Antenna
on the screen.
6
Press the Right or Left ADJ arrow to begin the Channel
Search.
7
Press ENTER when the channel search is complete.
Auto Program finds channels being received by the TV tuner.
Cable will not work unless the hospital provides a cable service.
Optional Installer and Patient Remote Controls:
Shown herein are optional remote controls that can be used by the
installer and the patient. Be advise that these remote controls are
NOT included with this TV. However, these remotes can be purchased
separately, see your Zenith dealer.
Mini glossary
OFF AIR ANTENNA If the patient can only view over-the-air broadcasts, select Antenna.
CABLE If you provide cable service to the patients, select Cable.
206-3491-O
POWER
1
1 2
4 5
7 8
0
BED 1
TIMER MENU
SELECT
3/5
ADJ
4/6
3
6
9
ENTER
7
BED 2
2
BANK
CH PREVIEW
ADJ
P A G E 1 1