Hook Up Cable Service (CATV)
Connect cable service to the TV
Locate the Antenna/Cable jack on the back of
1
the TV.
Connect the cable that runs from the wall
2
directly to this jack, according to the diagram
to the right.
Remove the back of the remote and put in two
3
AA batteries.
Plug in the TV. Do not plug it into a switched
4
outlet. Your TV is designed to operate on stan-
dard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Current.
Go to page 12 to Auto Program the TV.
5
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you're using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don't worry, that's all
you need!
P A G E 8
back of
remote
Cable TV
wall jack
RF coaxial wire (75 ohm)
Cable TV
wall jack
Cable box
In
output
Out
switch
3 4
RF coaxial wire (75 ohm)
TV back
ANTENNA
CABLE
VIDEO
MATRIX
IN
OUT
M.P.I.
R- AUDIO- L
IN
TV back
ANTENNA
CABLE
VIDEO
MATRIX
IN
OUT
M.P.I.
R- AUDIO- L
IN
206-3489-O