Antenna - Zenith HealthView H2050DT Installation And Operating Manual, Warranty

Hook Up The Antenna to the TV
Connect an off-air antenna to the HealthView
Locate the Antenna/Cable jack on the back of the
1
HealthView TV.
Connect the cable that runs from the wall directly to
2
this jack, according to the diagram to the right.
3
Remove the back of the remote and put in two AA bat-
teries.
4
Plug in the TV. Do not plug it into a switched outlet.
the HealthView TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt to oper-
ate it on DC Current.
5
Go to page 11 to Auto Program the HealthView
If you have a 75 ohm RF cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith HealthView
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of the TV.
300 TO 75 OHM A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
back of
remote
TV.
TV.
TV.

Antenna

Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF coaxial wire
(75ohm)
TV back
ANTENNA
CABLE
M.P.I.
PILLOW SPEAKER
TV back panel
(expanded view)
TV back
ANTENNA
CABLE
M.P.I.
PILLOW SPEAKER
TV back panel
(expanded view)
TV
SPKR
PILLOW
SPKR
TV
SPKR
PILLOW
SPKR
206-3491-O