Table of Contents
Advertisement
Installer Menus
Use the Installer Menus to make adjustments.
pital receivers). At "0" all four banks are active.
12 CHAN LOCK (Channel Lock)
When set to 1 the CHAN LOCK is ideal if a cable box (or similar) is
the sole source for programming—and the TV must always be on
the same channel. Changing channels with the Channel up/down or
or keypad numbers is impossible. Channel Lock is inactive when set
to 0 (default).
Generally, this feature is used in connection with START CHAN/VOL
(line 11) where the start channel may, for example, be set to 3 or
4. If the start channel is 3 then the TV will remain on channel 3.
NOTE: When channel lock is active AUTO PROGRAM and CH.
ADD/DEL in the SETUP MENU are not active.
13 GHOST CH. (Ghost Channel)
When set to 1, the current channel number is displayed in the
upper right corner of the CRT. The number moves slightly to pre-
vent damage to the screen. The default is "0" or OFF. NOTE: When
captions are on, the "ghost channel" is not displayed.
14 SCAN MODE
Allows variation in setting the On/Off with Channel UP/DOWN. You
may opt for TV channels only; TV channels + Off/ON; TV channels +
FM radio; TV channels + FM radio + Off/On with these settings for
Scan Mode:
Scan mode
Characteristics
0
Channel up/down keys change channels only.
1
Channel down below the lowest channel (or
channel up higher than the highest) and TV
turns off.
2
Channel down below the lowest channel (or up
higher than the highest) and TV goes to FM
radio. Channel down below lowest FM station
(or Channel up higher than the highest) and TV
channels return
3
Channel down below the lowest channel (or up
higher than the highest) and TV goes to FM
radio. Press channel down below lowest FM
station (or Channel up higher than the highest)
and TV turns off.
15 TEXT MODE
Determines whether TEXT 1 and TEXT 2 decoding is enabled when
CAPTIONS are turned on (either from the Setup Menu or directly
with CC on the remote). When set to 1, only Caption 1 and
Caption 2 are enabled. When set to 2, Caption 1, Caption 2, and
Text 1 and Text 2 are enabled.
TIP: Set Text Mode to 1 only if text is offered in your video system.
206-3491-O
16 SLEEP TIMER
When set to 1, a patient may use the SLEEP TIMER feature (but no
message is displayed prior to turn-off). When set to 0, the sleep
timer is not available.
17 ALARM
Gives you the option of making the alarm function available to the
end-user. Set to 1, alarm function is available. Set to 0 to withhold
this function.
18 CH. OVERRIDE (Channel Override)
When set to 1, the user is allowed to select channels with either
Channel up/down or by direct keypad entry. When set to 0, only
those channels that are entered for scanning may be selected.
19 OLD OCV (On Command Video )
Set to 1 for operation with "SpectraMate" systems from On
Command Corporation.
20 CAPTION LOCK
Set to 1 to restore previous caption On/Off state after TV turns off
when set to 0, captions are always off when TV is initially turned
on.
21 FUNCTION PRE
Set to 0 to suppress channel prev function with some pay per view
systems.
22 FEATURE LEVEL
Set to 1 for default Zenith features.
P A G E 3 1
Advertisement
Table of Contents
