Vcr Connections - Zenith C30W47 Installation And Operating Manual, Warranty

VCR Connections

Locate the Antenna 1 jack on the
1
back of your TV. Connect this to
out jack on the back of your VCR.
Or find the composite video and
audio jacks on the back of your
VCR, and connect them following
the instructions provided with
your equipment.
You may connect either the com-
posite video or the S-Video cables
to your TV. (Do not connect BOTH
the composite and the S- Video
cables. In the event that you con-
nect both composite and the S-
Video cables, only the S-Video will
work.)
To hear stereo sound from cable or your VCR,
you will need to connect A/V cables as well as
the wire that runs from the VCR to your TV.
If you want to receive your signals on Channel
3 or 4, locate the Out to TV jack on your VCR.
Connect a cable from the Out to TV jack to the
Antenna1 jack on the back of your TV.
206-04007
Back AV panel
RF coaxial wire
(75 ohm)
Output In
Switch
3 4
Out
S-Video
Audio
Video
or
R
L
VCR
ANTENNA 1 ANTENNA 2
+75 Ω +75 Ω
COMPONENT1 COMPONENT2
(480i/480p/720p/1080i)
R R
AUDIO AUDIO
L L
P P
R R
P P
B B
Y Y
DVD/DTV INPUT
A/V cables
not included
with TV
S-VIDEO VIDEO/AUDIO INPUT
AUDIO
VIDEO L(MONO) R
IN1
IN2
IN3
P A G E 1 1