Turning The Tv On; On-Screen Displays - Zenith C30W47 Installation And Operating Manual, Warranty

Turning the TV On

First, connect antenna cable and power cord correctly. At this moment, the TV switches to standby mode.
1
In standby mode to turn TV on, press the POWER, CH UP/DOWN, TV/VIDEO, SIDE, COMP/DVI or number but-
tons on the remote control or POWER, TV/VIDEO or CH UP/DOWN on the TV.
2
Select the viewing source by using TV/VIDEO, COMP/DVI or SIDE button on the remote control.
This TV is programmed to remember which mode it was last set to, even if you turn the TV off.
Note: See page 20 if you have not auto programmed the TV to receive channels in your local broadcast area.
When finished using the TV, press the POWER button on the remote control. The TV reverts to standby mode.
3
If you will be away on vacation, disconnect the power plug from the wall power outlet.

On-Screen Displays

This page describes your on-screen display and information banner options.
Mute
Appears when
sound is muted.
206-04007
Mute 10
Volume
Volume level is displayed
while adjusting the sound.
Main Channel Display
Displays current channel number.
TV 2-0
MONO
TV 12-0
10:00 AM
Time
Appears when pressing the
enter button on remote control.
Main Channel
Label
Displays current
channel label.
PIP Display
This display
appears when PIP
is active.
P A G E 1 7