Zenith C27V28 Operating Manual page 8

Hook Up an Off-Air Antenna
Connect an off-air antenna
1
Locate the Antenna/Cable jack on the back of
your Entertainment Machine.
2
Connect the wire that runs from the wall
directly to this jack, according to one of the
diagrams to the right.
3
Remove the back of the remote and put in two
"AA" batteries.
Back of
Remote
4
Plug in your TV. Do not plug it into an outlet
controlled by a switch. Your Entertainment
Machine is designed to operate on standard
household current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
120 V AC
60 Hz
If you have a 75 ohm RF cable, then you
don't need any adapters!
A 300 to 75 ohm adapter is not included with
the TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 8
Antenna
Flat Wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75 ohm)
Typical
TV Back
Typical
TV Back
206-03807